Filter
Top Products
www.petsafe.net 5
Locate the Fence Transmitter
Place the Fence Transmitter:
• In a dry, well ventilated, protected area (1A, 1B).
• In an area where temperatures do not fall below freezing (e.g., garage, basement, shed, closet).
• Secured to a stationary surface using appropriate mounting hardware (not included). A mounting template is
included on the back of this guide.
• At least 3 feet from large metal objects or appliances as these items may interfere with the signal consistency (1C).
Once you have mounted the Fence Transmitter, the Boundary Wire must exit the building. This can be
accomplished via a window or through a 1/8” hole drilled through the wall. Ensure the drill path is clear of any
utilities. Make sure the Boundary Wire is not cut off or pinched by a window, door, or garage door, as this can
damage it over time.
To prevent fi res and electrical hazards, install the Fence Transmitter in buildings that are in accordance with state
and local electrical codes.
1A
1B
3ft.
1C
__________________________________________________
Lay Out the System
Basic Planning Tips
• The Boundary Wire MUST start at
the Fence Transmitter and make a
continuous loop back (2A).
• Design a layout that is suitable for your
yard. Sample layouts are provided in
this section, and a grid for designing
your layout is provided on the back of
this guide.
•
Fence planning software is available
online at www.petsafe.net. After you
have planned and saved your layout
online, contact our Customer Care
Center to review and refi ne your layout.
• Twisting the Boundary Wire cancels
the signal and allows your pet to cross
over that area safely. Plastic or metal
10
Twists/ft.
2A 2B
piping will not cancel the signal. Twist the Boundary Wire 10 to 12 times per foot to cancel the signal (2A).
• Always use gradual turns at the corners to produce a more consistent boundary (2B). Do not use sharp turns,
as this will cause gaps in your boundary.
• Avoid making passageways too narrow for your pet to move about freely (e.g., along the sides of a house).•
The Receiver Collar can be activated inside the house if the Boundary Wire runs along the outside wall of the
house. If this occurs, remove your pet’s Receiver Collar before bringing him inside, decrease the range using
the Boundary Width Control knob or consider an alternative layout.
Operating Guide
Step
1
Step
2