Filter
Top Products
www.petsafe.net 11
Install the Boundary Wire
To Bury the Boundary Wire
Burying the Boundary Wire is recommended to protect it and prevent disabling the system.
1. Cut a trench 1-3 inches deep along your planned boundary.
2. Place the Boundary Wire into the trench maintaining some slack to allow it to expand and contract with
temperature variations.
3. Use a blunt tool such as a wooden paint stick to push the Boundary Wire into the trench. Be careful not to
damage the Boundary Wire.
To Attach the Boundary Wire to an Existing Fence
The Boundary Wire of the PetSafe
®
In-Ground Radio Fence
™
can be attached to a chain link fence, split rail
fence, or a wooden privacy fence. The Boundary Wire can be attached as high as needed. However, make sure the
Boundary Width is set at a high enough range for the pet to receive the signal. If using a Double Loop with an
existing fence at least three feet tall, run the Boundary Wire on top of the fence and return it on the bottom of the
fence to get the three to fi ve foot separation needed.
• Chain Link Fence (7A): Weave Boundary Wire through the links or use plastic quick ties.
• Wooden Split Rail or Privacy Fence (7A): Use staples to attach Boundary Wire. Avoid puncturing the
insulation of the Boundary Wire.
• Double Loop with an Existing Fence: Run the Boundary Wire on top of the fence and return it on the bottom
of the fence to get the three to fi ve foot separation needed.
• Gate (Single Loop) (7B): Bury the Boundary Wire in the ground across the gate opening. Note: The signal is still
active across the gate. Your pet cannot pass through an open gate.
• Gate (Double Loop) (7B): Bury both Boundary Wires across the gate opening while keeping them three to fi ve
feet apart.
STAPLE WIRE TO FENCE
WEAVE WIRE INTO FENCE
STAPLE WIRE
TO FENCE
7A
3'-5'3'-5'
SINGLE LOOP
DOUBLE LOOP
7B
Step
7