Filter
Top Products
C3428M-A (1/08) 7
Installation
PREPARE MOUNTING SURFACE
1. Remove the cover of the IS210. Use the screwdriver bit (supplied) to loosen the three tamperproof
screws, and then lift the cover from the base.
2. Remove the camera assembly from the base by removing the Phillips screws on each side of the
camera assembly (refer to Figure 2).
Figure 2. Removing Camera Module
3. Remove the base from the mounting plate by removing the three 8-32 x 0.375-inch screws and
washers. Lift the base from the mounting plate and set aside the base, screws, and washers.
4. Select a fixed or adjustable mounting pattern (refer to Figure 3 and Figure 4 on page 8). Using the
mounting plate as a template, mark the wire feedthrough and fastener hole positions on the
mounting surface. Prepare the holes for the installation.
CAMERA ASSEMBLY
PHILLIPS
SCREW