Filter
Top Products
12 C3428M-A (1/08)
REINSTALL CAMERA MODULE
Reinstall the camera module (refer to Figure 8). Make sure the top of the camera is oriented properly; the
lens housing contains a label that reads TOP.
NOTE: To prevent damage to the camera or lens, install the camera in the correct hole positions of the
mounting bracket.
Figure 8. Camera Installation
ADJUST POSITION
1. Turn on power to the camera and monitor.
2. Varifocal lens only: Loosen the focal length and focus locking screws (refer to Figure 9). Adjust
the lens according to scene detail. Retighten the screws.
Figure 9. Varifocal Lens Adjustment
3. Adjust the position of the camera.
REPLACE COVER
Place the cover of the IS210 onto the base of the unit. Using the screwdriver bit (supplied), tighten the
three tamperproof screws.
NOTE: Remove the foam from the inside of the cover before installing the cover.
WARNING: Heater elements could be hot! When camera power is on, use caution when
adjusting the camera. This applies to all models.
DO NOT USE
MOUNT CAMERA HERE
LOCKING
SCREWS
VARIFOCAL LENS