Filter
Top Products
C1645M-A (9/06) 17
Mounting the Transmitter/Receiver Using the Wall Clip
NOTE: Before mounting the FT85041 transmitter/FR85041 receiver to a wall, ensure that there is
adequate space at both ends for viewing the front-panel LEDs and for making the various rear-panel
cable connections.
To attach the FT85041 transmitter/FR85041 receiver to a wall using the supplied wall clip, refer to
Figure 7 and do the following:
1. Using the two vertical or horizontal wall-mounting holes, attach the wall clip to a wall using
two screws (not provided).
2. Slide the module into the clip until the two holes on the bottom of the module align with the
two holes on the lower flange of the clip.
3. Attach the module to the clip using the two Phillips pan head screws provided for the clip.
Figure 7. Mounting the FT85041 Transmitter/FR85041 Receiver Using the Wall Clip
TRANSMITTER/
RECEIVER
WALL CLIP
LOWER
FLANGE
SCREW, PHILLIPS
PAN HEAD WITH
LOCK WASHER (2)
HORIZONTAL
MOUNTING HOLE (2)
UPPER
FLANGE
VERTICAL
MOUNTING HOLE (2)
C1645M-A.book Page 17 Wednesday, September 13, 2006 3:07 PM