Filter
Top Products
16 C1645M-A (9/06)
MOUNTING
The FT85041 transmitter/FR85041 receiver can be mounted into a rack or can be used as a stand-
alone module. As a stand-alone module, the unit can be placed on a desktop or can be mounted to a
wall.
NOTE:
As a matter of convenience, it is recommended that you set the desired data communication
before mounting the FT85041 transmitter/FR85041 receiver. To set the desired data communication,
refer to the
Data Communication Setup
section.
MOUNTING THE TRANSMITTER/RECEIVER INTO A RACK
The FT85041 transmitter/FR85041 receiver can be installed into an RK5000 Series rack mount
chassis, which can be mounted into an industry-standard 19-inch (48.26 cm) equipment rack.
The RK5000 Series rack mount chassis includes the following models:
•
RK5000PS-3U and RK5000-3U:
Designed to accommodate fiber optic modules as follows:
–
The RK5000PS-3U rack mount chassis provides 12 single-width module slots and a
power supply.
–
The RK5000-3U rack mount chassis provides 14 single-width module slots (a power
supply is not included). Power to the modules can be supplied using the optional external
power supply (EPS5000-120).
For additional information, refer to the RK5000PS-3U/RK5000-3U Fiber Rack Mount Chassis
Installation manual.
•
RK5000PS-5U:
Designed to accommodate Endura
™
modules but can also accommodate fiber
optic modules with the use of the appropriate adapter kit. The RK5002-1UEXP adapter kit is
required for installation of the FT85041 transmitter/FR85041 receiver into the RK5000PS-5U
chassis.
For information about the RK5000PS-5U chassis, refer to the RK5000PS-5U Rack Mount Chassis
Installation manual.
NOTE:
The FT85041 transmitter/FR85041 receiver is a double-width fiber optic module that
occupies two slots in the RK5000PS-3U, RK5000-3U, and RK5000PS-5U chassis.
MOUNTING THE TRANSMITTER/RECEIVER TO A WALL
The FT85041 transmitter/FR85041 receiver can be mounted to a wall in the following ways:
•
Using the supplied wall clip for attachment of a single module to a wall. For installation
instructions, refer to the
Mounting the Transmitter/Receiver Using the Wall Clip
section.
•
Using the optional WM5002 wall mount kits, which are designed for mounting of double-
width fiber optic modules. The WM5002-3U base kit allows mounting of a single module to a
wall. The WM5002-3UEXP expansion kit allows mounting of an additional module. It is
recommended that a maximum of one expansion kit be used with the base kit, allowing a
maximum of two double-width modules to be mounted to a wall.
NOTE: The WM5002 wall mount kits can be used with the WM5001 wall mount kits, which
are designed for mounting of single-width fiber optic modules. If mounting a mix of single-width
and double-width modules is desired, it is recommended that a maximum of two single-width
modules and one double-width module be mounted in combination with one another.
For mounting instructions using the wall mount kits, refer to the WM5000 Series Wall Mount
Kit Installation manual.
C1645M-A.book Page 16 Wednesday, September 13, 2006 3:07 PM