Filter
Top Products
ADDENDUM
Pelco Worldwide Headquarters
3500 Pelco Way • Clovis, California 93612 USA
USA & Canada
• Tel: 800/289-9100 • Fax: 800/289-9150
International
• Tel: 1-559/292-1981 • Fax: 1-559/348-1120
www.pelco.com
®
Pelco and the Pelco logo are registered trademarks of Pelco. ©Copyright 2006, Pelco. All rights reserved.
The materials used in the manufacture of this document and its components are
compliant to the requirements of Directive 2002/95/EC.
Addendum No.
C1645M-A ADDEN
Date
September 14, 2006
Manual Affected
FT85041/FR85041 Fiber Transmitter and Receiver
Installation Manual –
C1645M-A
Manual Update
Attachment of Ferrite to Data Cable of FT85041/
CT85041 Transmitter
A snap-on ferrite is supplied with the
FT85041MSTR/CT85041MSTR, FT85041SSTR/
CT85041SSTR, and FT85041SFCR/CT85041SFCR
transmitters. The ferrite must be attached to the
data cable of the transmitters to comply with FCC
and CE emissions requirements.
After the data connections are made to the data
connector on the transmitter, attach the ferrite to
the data cable. When attaching the ferrite to the
cable, position the ferrite as close as possible to
the transmitter.
NOTE:
The ferrite should fit securely around the
cable. If the ferrite is loose and slides along the
cable, loop the cable through the ferrite before
closing the ferrite. If, however, the thickness of
the cable prevents the ferrite from closing, use a
tie wrap to hold the ferrite in place rather than
looping the cable.