Filter
Top Products
8 C3407M-D (1/07)
SUSPENDED CEILING
NOTE:
You should install the camera module into the back box before installing the back box into the
surface. When installing the back box into the surface, rotate the camera module to access the
mounting holes. Refer to
Camera Module
on page 10 for more information.
1. Pull video and power wires to the ceiling tile.
2. Mount the unit to the ceiling tile (refer to Figure 3):
a. Remove the ceiling tile from the ceiling.
b. Cut a hole 3.5 inches (9 cm) in diameter in the ceiling tile. Use the supplied adapter
plate as a template. Punch four screw holes in the ceiling tile.
c. Attach the back box to the ceiling tile and adapter plate with four supplied
8-32 x 1.25-inch Phillips flat head screws.
d. Reinstall the ceiling tile with the unit.
Figure 3.
Ceiling Tile Installation
3. Remove an adjacent ceiling tile.
4. Connect the video cable/wires:
BNC:
Connect the BNC connector from the unit to a mating BNC connector.
Twisted Pair (UTP):
Blue wire = Video +
Gray wire = Video -
5. Connect the power wires.
AC operation only:
If you are wiring more than one Camclosure integrated camera system to
the same transformer, connect one side of the transformer to the red wire on all units, and
connect the other side of the transformer to the black wire on all units. Failure to connect all of
the units the same way will cause the cameras to be out of phase with each other and may
produce a vertical roll when switching between cameras.
Voltage Red Wire Black Wire
12 VDC + Ground
24 VAC ~ ~
8-32 X 1.25-INCH
PHILLIPS FLAT
HEAD SCREWS
(SUPPLIED)
BACK BOX
CEILING TILE
ADAPTER PLATE