Filter
Top Products
12 C3407M-D (1/07)
CAMERA ORIENTATION
At the factory, the camera module is configured for ceiling mounting. For wall mounting, you must
change the camera orientation or the video image will be upside down.
To change the camera orientation (refer to Figure 7):
1. Remove the camera module from the back box if necessary.
2. Remove the tilt adjustment screw and lock washer from each side of the camera.
3. Carefully rotate the camera one half turn. Make sure the wiring harness does not bind.
4. Reinstall the tilt adjustment screw and lock washer on each side of the camera.
5. Verify the camera orientation.
Figure 7.
Camera Orientation
MODULE INSTALLATION
To install the camera module into the back box:
1. Plug the camera (10-pin), heater board (four-pin), and service (three-pin) connectors into the
back box (refer to Figure 6 on page 11).
2. Make sure the tabs on the camera bracket and the service connector are pointing out of the
enclosure, away from the ceiling or wall.
3. Gently squeeze the bracket, place it against the groove inside back box, and gently release
(refer to Figure 5 on page 10).
BOTTOM
OF CAMERA
TILT ADJUSTMENT
SCREW AND
LOCK WASHER
CEILING MOUNT (DEFAULT) WALL MOUNT
TOP OF
CAMERA
TILT ADJUSTMENT
SCREW AND
LOCK WASHER