Filter
Top Products
8 of 11
ISSUED: 09-05-06 SHEET #: 202-9166-7 11-10-08
Note: "X" dimensions should be equal.
• Tighten screws so adapter brackets are firmly attached. Do not tighten with excessive force. Overtightening can cause
stress damage to screws, greatly reducing their holding power and possibly causing screw heads to become
detached. Tighten to 40 in. • lb (4.5 N.M.) maximum torque.
• If screws don't get three complete turns in the screen inserts or if screws bottom out and bracket is still not tightly
secured, damage may occur to screen or product may fail.
WARNING
Installing Adapter Brackets
To prevent scratching the screen, set a cloth on a flat, level surface that will support the weight of the screen. Place screen
face side down. Refer to screen manufacturers instructions or customer service, for removing any knobs, base, cover, or
screw(s) on the back of the screen to prepare mounting. These need to be removed to allow the adapter brackets to be
attached. Select the small, medium, large or extra large screws from the baffled fastener pack then attach tilt brackets to
screen following figure 13.1 or 13.2.
NOTE: Top and bottom mounting holes must be used for attaching brackets. Verify that all holes are properly aligned, and
then tighten screws using a phillips screwdriver.
MEDIUM HOLE FOR M5 SCREWS
SMALL HOLE FOR M4 SCREWS
LARGE HOLE FOR M6 SCREWS
G
CENTER BRACKETS VERTICALLY
ON
BACK OF SCREEN
X
X
Notes:
• The number of fasteners used will vary,
depending upon the type of screen.
• Multi-washers and spacers may not be
used, depending upon the type of screen.
• Use the corresponding hole in the multi-
washer that matches your screw size as
shown.
MULTI-WASHER
13
NOTE: For flat back screens proceed to step 13-1. For bump-out or recessed back screen skip to step 13-2.