Filter
Top Products
4 of 11
ISSUED: 09-05-06 SHEET #: 202-9166-7 11-10-08
M6 x 20 mm (4)
520-9402
M6 x 30 mm (4)
510-9109
multi-washer (6)
580-1036
M8 x 16 mm (6)
520-9257
M8 x 40 mm (4)
520-1136
M4 x 12 mm (6)
504-9013
Phillips Adapter Bracket Fasteners
M4 x 25 mm (4)
504-1015
M5 x 12 mm (4)
520-1027
M5 x 25 mm (4)
520-9543
M6 x 12 mm (4)
520-1128
M6 x 25 mm (4)
520-1208
I.D. .22" (5.6 mm) (4)
540-1057
M8 x 25 mm (4)
520-1031
I.D. .34" (8.7 mm) (4)
540-1059
1
Cut adhesive felt (S) into four pieces as shown in figure 1.1 below and affix to bottom of base (E).
1-1
Attach upright (H) to base (E) using three 3/8-16 x 2.5" socket screws (P). Tighten screws using 7/32"
allen wrench (Q).
P
E
H
S
1-2
CORD MANAGEMENT HOLE
CORD MANAGEMENT HOLE
Run cords through upright (H) using cord management holes as shown in figure 1.2.
fig. 1.1
fig. 1.2
H
CORD MANAGEMENT HOLE