Filter
Top Products
- 11 -
Voltaje
Protector termal
Extensión de cordón
Herramientas
120 V c.a. (60 Hz)
Si 10.6 m (35pi) Si
Power Thermal Protector Cord Length Tools
120V AC (60 Hz)
Yes 10.6 m (35Ft.) Yes
Alimentation
Protecteur thermique
Longueur du cordon Accessoires
120 V c.a. (60 Hz)
Oui 10.6 m (35 pi) Oui
FEATURE CHART
Diagrama de características
Tableau des caractéristiques
- 38 -
Nozzle Hose
Tuyau
Manguera
Hose Inlet
Entrée du tuyau
Conecciónde
manguera
Removing Clogs
Body Hose
Tuyau
Manguera
Cover
(Suction Inlet)
Couvercle
(entrée
d’aspiration)
Cubierta
(Abertura de
aspiración)
Nozzle Hose
Tuyau de tête
d'aspiration
Manguera de
Boquilla
The body hose located on the back of
the vacuum cleaner carries the dirt from
the nozzle up to the dust bag. If the
hose should become clogged:
➢➢
Unplug vacuum cleaner.
➢➢
Pull open suction inlet cover and
check for clogging. Secure suction
inlet cover properly after checking.
➢➢
Disconnect body hose from wand
holder and check hose ends.
➢➢
Plug in vacuum cleaner and turn on.
➢➢
Stretch body hose in and out to
remove clogs that may not be seen.
➢➢
If clog still exists, turn vacuum
cleaner OFF and UNPLUG PO
WER
CORD.
➢➢
Remove lower plate. See: “Removing
and Installing Lower Plate”
➢➢
Inspect inlet of nozzle hose and clear
any obstructions.