Panasonic 30003 Indoor Furnishings User Manual


 
22
3
Set the time and intensity for the neck, shoulder, back, and lower back,
respectively ( ).
The level shifts sequentially whenever the button is pressed.
Display
How to shift the level
Press the button to shift the levels for “NECK,” “SHOULDER,” “MIDDLE,” and “LOWER” by one up/down at the same
time.
3 bars represents more time than one bar.
If all areas are 3 bars, then both time will be equally long and the massage will be strong in all areas.
If all areas are just one bar, then massage length will be the same, and intensity will be lighter.
4
Press the button to start the program.
The massage will start after the body scanning.
To change the time and intensity in the middle of a massage
Set the condition again with Steps
3
and
4
.
Press the button within approximately 30 seconds after resetting in Step
3
, otherwise the reset will be cancelled
automatically.
Setting the Time and Intensity
In the Self-Program, the actions and time for the respective
body parts will be set according to the settings picked by the
user. Fewer bars means both less time and less strength. If
you don’t want a massage at all in an area, set the bars to
“0”.
Massage Sequence
The massage starts in the area with the highest numbers of
bars selected, and moves successively from highest to
lowest.
If the levels of fatigue are the same, the massage will follow
the sequence of “NECK,” “SHOULDER,” “MIDDLE,” and
then “LOWER.”
Massage actions for the respective level of
fatigue
Stronger massage mainly Shiatsu
Massage at an intermediate level, mainly
Kneading
Softer massage mainly Swedish
No massage for this part
During a massage
To change off/on for “LEG/FOOT” and adjust its intensity, see page 28.
If you want to turn the leg stretch massage off/on, see page 30.
If you want to adjust the legrest, see page 31 and 32.
If you want to adjust the intensity and position of the massage on the upper body using the massage heads, see page 26
and 27.
If you want to adjust the reclining angle, see page 31.
If you want to use the “ULTRA KNEAD” function or “REPEAT” function, see page 26.
If you want to finish a massage, see page 38 and 39.
EP30003.indb 22 2007/07/19 13:05:17