Filter
Top Products
13
When removing the control panel stand cover
1. Insert the head of a flat-tip screwdriver in the gap
under the mark (O).
2. Push the bottom tab of the cover up to lift the cover.
3. Perform the same procedures as 1 and 2 above for
the other gap.
4. Pull the cover up diagonally.
Performing this procedure with the allen key or a
Phillips screwdriver could damage the unit.
•
4
Raising the backrest to the
upright position
1. Insert the power plug into the power outlet.
2. Confirm the key lock is set to the “open”
position.
3. Confirm the power switch is set to the “on”
position.
4. Press the
button on the control panel
twice.
The backrest will rise to the upright position
automatically.
Flat-tip
screwdriver
(Not included in
the standard
configuration)
Gap
1
2
2
EP30003.indb 13 2007/07/19 13:05:08