Filter
Top Products
19
2. Approximately 30 seconds after the body scanning starts, the massage heads slowly lower to the shoulder
position, and a soft tapping action begins to determine your shoulder height.
Massage Head
Tapping
action
Keep your head on the pillow until the soft tapping begins.
Lifting your head from the pillow will result in incorrect
determination of the shoulder position.
3. Confirm that the shoulder position has been correctly determined according to the position of the soft tapping.
Too low
Too high
Correct position of the massage head
(The point where the tapping action should be felt.)
When the shoulder position is incorrect, adjust the shoulder position while the soft tapping is in progress (for
approximately 15 seconds), and use the POSITION button to move the massage heads up or down.
A single press of the button will raise or lower
the massage heads approximately 0.5" (1.2 cm).
4. The massage will start after body scanning is complete.
The legrest height will adjust automatically based on the body scanning results. The soles of the feet should be touching
the footrest wells. You may still adjust the length of the legrest with the lever on the right side of the seat (see below). You
may also further adjust the height of the ottoman electronically (see page 31).
•
During a massage
To change off/on for “LEG/FOOT” and adjust its intensity, see page 28.
If you want to turn the leg stretch massage off/on, see page 30.
If you want to adjust the legrest, see page 31 and 32.
If you want to adjust the intensity and position of the massage on the upper body using the massage heads, see page 26
and 27.
If you want to adjust the reclining angle, see page 31.
If you want to use the “ULTRA KNEAD” function or “REPEAT” function, see page 26.
If you want to finish a massage, see page 38 and 39.
•
•
•
•
•
•
•
Adjust the length of the legrest to accommodate the position of
the backs of your calves or knees to fit into the legrest wells.
When the massage starts
Push the legrest with the sole
of your foot while pulling the
legrest slide lever.
EP30003.indb 19 2007/07/19 13:05:13