Filter
Top Products
7
Shooting
How to turn the power on and off
Turning the power on
When performing the operations
using the wireless remote control
1 Set all the power switches of the units and
devices connected in the system to ON.
This unit does not have a power switch.
When power is supplied to it, the status display lamp
will light up orange, and the unit is set to the standby
mode.
2 Press one of the [CAM1] to [CAM4] buttons on
the wireless remote control to select the unit.
3 Press the [ON/STANDBY] button on the
wireless remote control for 2 seconds.
The POWER ON mode is established, images are
output, and control can be exercised.
The unit’s status display lamp now lights up green.
It takes maximum 30 seconds per unit for the initial
settings operation to be completed.
During this period, the unit cannot be operated.
(Status display lamp: light up orange)
When operation is transferred to the STANDBY
mode: The current zoom, focus and iris positions
are stored in the memory (POWER ON preset).
When operation is transferred to the POWER ON
mode: The zoom, focus and iris are adjusted to
the positions which were stored in the memory
(POWER ON preset) when operation was
transferred to the STANDBY mode.
Notes
4 If a multiple number of units are going to be
used, repeat steps
2 and 3 as required.
The unit’s status display lamp blinks green when a signal
matched by the remote control ID has been received, and
it blinks orange when a signal that is not matched by the
remote control ID has been received.
When performing the operations using the controller
When the AW-RP655 or AW-RP555 is connected:
1 Set all the power switches of the units and
devices connected in the system to ON.
This unit does not have a power switch.
When power is supplied to it, the status display lamp
will light up orange, and the unit is set to the standby
mode.
2 Set the [OPERATE] switch on the controller to
ON.
The POWER ON mode is established, images are
output, and control can be exercised.
The unit’s status display lamp now lights up green.
It takes maximum 30 seconds per unit for the initial
settings operation to be completed.
During this period, the unit cannot be operated.
(Status display lamp: light up orange)
When operation is transferred to the STANDBY
mode: The current zoom, focus and iris positions
are stored in the memory (POWER ON preset).
When operation is transferred to the POWER ON
mode: The zoom, focus and iris are adjusted to
the positions which were stored in the memory
(POWER ON preset) when operation was
transferred to the STANDBY mode.
Notes
Before setting the [OPERATE] switch on the controller to ON,
be absolutely sure to set all the power switches of the units
and devices connected in the system to ON.
For further details, refer to the Operating Instructions of the
controller.
When the AW-RP50 is connected:
Refer to the Operating Instructions of the controller.