The SB-28 comes with a wide flash adapter to increase the angle of
coverage to match an 18mm or 20mm lens.
1
Slide out the wide flash adapter 1 and gently push it down into
place in front of the flash head 2.
• Because the bounce card comes out at the same time, return it 3 to its
original position inside the flash head.
• The zoom-head position indicator changes to 20mm and the indicator bars _
display the appropriate flash shooting distance range.
2
To change to 18mm, press the ' button once.
—The zoom-head position indicator toggles between 18mm and 20mm each
time you press the ' button.
• To replace the wide flash adapter, lift it up and slide it back into its original
place inside the flash head.
If the built-in wide flash adapter is broken off accidentally, it is
no longer possible to set 18 or 20mm.
In this case, press the ' and [ buttons simultaneously for
approx. 4 sec. until the zoom-head position indicator starts blinking,
making it possible to adjust the zoom-head automatically or manually to its
six basic settings (24, 28, 35, 50, 70, 85mm).
21
Setting the built-in wide flash adapter