Filter
Top Products
W415-0594 / A / 02.15.07
26
A bed of ashes approximately 1 inch deep should be left on
the firebox bottom to help maintain a hot charcoal bed.
When the fire has burned down and cooled, remove any
excess ashes. To remove the ash, follow the directions
below.
1. After the last coal has extinguished, let the fireplace cool
at least two hours.
2. Open the fireplace doors.
3. Scoop the ash from the firebox into a metal, airtight, con-
tainer with a lid. Cover the container with the lid and move
the container away from the fireplace to ensure the ashes
cool. Dispose of the ashes.
Warning: Improper disposal of ashes result in fires. Do
not discard ashes in cardboard boxes, dump in back yards,
or store in garages.
Note: If using a vacuum to clean up ashes, be sure the
ashes are entirely cooled. Using a vacuum to clean up
warm ashes could cause a fire inside the vacuum.
ASH REMOVAL PROCEDURES
When refueling open the door slowly to prevent smoke
spillage. Use a pair of long fireplace gloves when feeding
the fire. Keep a small steel shovel nearby to use as a
poker and to remove ashes. Do not store wood within 4
feet (1m) of the fireplace.
Follow the directions below to minimize smoke spillage
while re-loading the fireplace.
1. Move the air control to high.
2. Open the door slightly. Allow the airflow inside the firebox
to stabilize before opening the doors fully.
3. Load wood to the top of the cast retainers and burn at a
medium low setting.
A flash fire is a small fire burned quickly when you don't
need much heat. After your kindling has "caught", load at
least 3 pieces of wood, stacked loosely. Burn with the draft
control fully open or closed only slightly.
This fireplace is large enough to accomodate overnight,
14 hour burns. Follow these steps below to achieve an
overnight burn.
1. Get the fireplace hot by moving the air control to high
and letting the fireplace burn for 15 minutes.
2. Load your larger pieces of wood compactly, packed close
enough to prevent the flames from penetrating it completely.
RE-LOADING THE FIREPLACE
FLASH FIRES
OVERNIGHT BURN
3. After approximately 30 minutes, depending on the size of
the load, close the draft control completely making sure
that the fire is not extinguished.
4.In the morning the fireplace should still be hot, with
embers in the coal bed. Stir the coals and load small pieces
of wood to re-ignite the fire, if desired.
Note: Differences in chimney height and draft may lower
overall burn times.
DO NOT OVERFIRE THE FIREPLACE! Overfiring can occur
by: a) burning large amounts of smaller wood pieces. b)
vigorously burning large loads of wood with the draft control
on "HIGH" (fully open) for long periods of time (one or two
hours).