Filter
Top Products
W415-0594 / A / 02.15.07
20
3. Connect the 6” collar to the blower opening located
on the side of the unit. An optional opening is covered on
the other side of the unit. If this location is preferred, switch
the cover plate and collar.
Secure by reaching through the collar and bending the
tabs.
Use sealant to ensure that the connection is air tight.
NZ64 BLOWER INSTALLATION
This unit is supplied with a pressure switch andThis unit is supplied with a pressure switch and
This unit is supplied with a pressure switch andThis unit is supplied with a pressure switch and
This unit is supplied with a pressure switch and
a thermally activated switch. Ensure that thea thermally activated switch. Ensure that the
a thermally activated switch. Ensure that thea thermally activated switch. Ensure that the
a thermally activated switch. Ensure that the
pressure switch actuating arm protrudespressure switch actuating arm protrudes
pressure switch actuating arm protrudespressure switch actuating arm protrudes
pressure switch actuating arm protrudes
through the faceplate when installed.through the faceplate when installed.
through the faceplate when installed.through the faceplate when installed.
through the faceplate when installed.
The blower will only operate when the doors areThe blower will only operate when the doors are
The blower will only operate when the doors areThe blower will only operate when the doors are
The blower will only operate when the doors are
fully closed.fully closed.
fully closed.fully closed.
fully closed.
We recommend installing the blower in a different room or
even different level of the house. This will generate greater
air movement and improve the distribution of the warm air
coming from the fireplace.
1. Remove the template.
2. Position the blower to an in-
side or outside wall into a framed open-
ing 12
3
/
8
” wide by 10
1
/
2
” high. (Outside wall
not recommended in colder climates as cold air may
be drawn into the house when the fireplace is off.)
The blower housing should be installed onto aThe blower housing should be installed onto a
The blower housing should be installed onto aThe blower housing should be installed onto a
The blower housing should be installed onto a
level surface large enough to support the blowerlevel surface large enough to support the blower
level surface large enough to support the blowerlevel surface large enough to support the blower
level surface large enough to support the blower
assembassemb
assembassemb
assemb
lyly
lyly
ly
..
..
.
Allow for finishing material when securing theAllow for finishing material when securing the
Allow for finishing material when securing theAllow for finishing material when securing the
Allow for finishing material when securing the
blower housing, as the grill mounts to the hous-blower housing, as the grill mounts to the hous-
blower housing, as the grill mounts to the hous-blower housing, as the grill mounts to the hous-
blower housing, as the grill mounts to the hous-
ing.ing.
ing.ing.
ing.