Filter
Top Products
24
W415-0299 / C / 03.12.03
FIGURE 50
Attach the hood with louvre brackets by pressing the top
flange of the bracket into the clips along the top of the
louvre opening with louvre securing tabs facing out.
Using 6 screws, attach the lower louvre brackets and hinge
screen as illustrated. Be sure to install the louvre brack-
ets over the hinge screen.
FIGURES 51 a-b
A
B
Tear the embers into small pieces and place on the ported
area of the burner. Care should be taken to shred the
embers into thin, small irregular pieces as only the ex-
posed edges of the fibre hairs will glow. The ember mate-
rial will only glow when exposed to direct flame; however,
care should be taken to not block the burner ports. Blocked
burner ports can cause an incorrect flame pattern, carbon
deposits and delayed ignition. PHAZER
TM
logs glow when
exposed to direct flame.
Randomly place the embers around the bottom brick pan-
els in a realistic manner but not in contact with the flames.
Keep ember dust away from burner ports to avoid plugging
them.
Fine dust found in bottom of bag not to be used. PHAZER
TM
logs, and embers glow when exposed to direct flame. Use
only certified PHAZER
TM
logs, glowing embers and char-
coal embers available from your Napoleon / Wolf Steel Ltd.
dealer.
47
GLOWING EMBERS
DOOR OPENING AND
CLOSING: The upper lou-
vres must be removed to
allow the door to be
opened or closed. To ac-
cess the lower door latch,
open the valve control door.
Release the top and bot-
tom door latches, located
at the right side of the door.
TO INSTALL THE UP-
PER LOUVRES: Insert
the upper louvres into the
slots on both brackets.
Press the top flange of
the hood into the four
clips located along the
top of the unit as shown.
TO INSTALL THE LOWER
LOUVRE ASSEMBLY: At-
tach each hinge to the fire-
box with 2 screws.
Optional plated door trim, and arched door facia are avail-
able at your local Napoleon dealer.
LOUVRE
HOOD
SLOT
BRACKET
LOWER LOUVRES
(VALVE CONTROL DOOR)
52
53
GLOWING EMBERS
CHARCOAL EMBERS
DOOR INSTALLATION
UPPER LOUVRE BRACKETS & HOOD
LOWER LOUVRE BRACKETS & HINGE SCREEN
DOOR LATCH
HOOD
UPPER LOUVRE
49
FLANGE
CLIP
GVFL INSTALLATION
Remove the
backing of the
logo supplied and
place on the glass
viewing door, as
indicated.
LOGO
½"
½"
LOGO PLACEMENT
FIGURE 48