Filter
Top Products
2
W415-0619 / B / 03.03.08
PG 2-5 INTRODUCTION
Warranty
General Instructions
General Information
Care of Glass and Plated Parts
Dimensions
5-10 VENTING
Venting Lengths and Air Terminal Locations
Vent Installations
Typical Vent Installations - Horizontal Termination
Typical Vent Installations - Vertical Termination
Minimum Air Terminal Location Clearances
Venting Application Flow Chart
10-15 INSTALLATION/FRAMING
Wall and Ceiling Protection
Vertical Installation
Using Flexible Vent Components
Horizontal Air Terminal Installation
Vertical Air Terminal Installation
Fireplace Vent Connection
Mobile Home Installation
Gas Installation
Electrical Connection
Stand-off Assembly
Nailing Tab Installation
Framing
Clearance to Combustibles
• Do not burn wood or other materials in this fi replace.
• Adults and especially children should be alerted to the hazards of high surface temperatures and should stay away to avoid burns or clothing ignition.
Supervise young children when they are in the same room as the fi replace.
• Clothing or other fl ammable material should not be placed on or near the fi replace.
• Due to high temperatures, the fi replace should be located out of traffi c and away from furniture and draperies.
• Ensure you have incorporated adequate safety measure to protect infants/toddlers from touching hot surfaces.
• Even after the fi replace is out, the glass and/or screen will remain hot for an extended period of time.
• Check with your local hearth specialty dealer for safety screens and hearth guards to protect children from hot surfaces. These screens and guards
must be fastened to the fl oor.
• Any safety screen or guard removed for servicing must be replaced prior to operating the fi replace.
• It is imperative that the control compartment and burner in the fi replace and venting system are kept clean. The fi replace and its venting system
should be inspected before use and at least annually by a qualifi ed service person. More frequent cleaning may be required due to excessive lint
from carpeting, bedding material, etc. The fi replace area must be kept clear and free from combustible materials, gasoline and other fl ammable
vapours and liquids.
• Under no circumstances should this fi replace be modifi ed.
• This fi replace must not be connected to a chimney fl ue pipe serving a separate solid fuel burning appliance.
• Do not use this fi replace if any part has been under water. Immediately call a qualifi ed service technician to inspect the fi replace and to replace any
part of the control system and any gas control which has been under water.
• Do not operate the fi replace with the glass door removed, cracked or broken. Replacement of the glass should be done by a licensed or qualifi ed
service person.
• Do not strike or slam shut the fi replace glass door.
• The glass door must be kept closed while the fi replace is operating to prevent exhaust fumes containing carbon monoxide, from entering into the
home. Temperatures of the exhaust escaping through this opening can also cause the surrounding combustible materials to overheat and catch fi re.
• Only doors / optional fronts certifi ed with the unit are to be installed on the appliance.
TABLE of CONTENTS
NOTE: Changes, other than editorial, are denoted by a line in the margin.
This appliance may be installed as an OEM installation in a manufactured home (USA
only) or mobile home and must be installed in accordance with the manufacturers
instructions and the Manufactured Home Construction and Safety Standard, Title 24
CFR, Part 3280 in the United States or in the Mobile Home Standard, CAN/CSA Z240
MH, Series in Canada.
This appliance is only for use with the type of gas indicated on the rating plate. This
appliance is not convertible for use with other gases, unless a certifi ed kit is used.
This appliance may be installed in an aftermarket, permanently located, manufactured
home (USA only) or mobile home, where not prohibited by local codes.
This appliance is only for use with the type of gas indicated on the rating plate. This
appliance is not convertible for use with other gases, unless a certifi ed kit is used.
15-17 FINISHING
Door Removal
Glass Removal
Frame/Front Installation
Accent Glass Installation
LK8 Light Installation (Optional)
18 OPERATING INSTRUCTIONS
19 MAINTENANCE
19 ADJUSTMENTS
Gas Pressure Adjustment
Venturi Adjustment
Flame Characteristics
20 REPLACEMENTS
Replacement Parts
Flexible Vent Kits
Terminal Kits
Accessories
!
WARNING