Filter
Top Products
20
W415-0547 / B / 05.08.06
LOG PLACEMENT
LOGO PLACEMENT
LOGO
1.27cm
1.27cm
Remove the backing from the the logo and position onto the
control door as shown.
It is not necessary to remove the cast front, however, this
will make for a more simple log installation.
In order to assemble the log set, the door must be removed,
see Cast Front / Glass Door Removal in the FINISHING
section of this manual.
1. Place the rear log, as shown, onto the rear log support
brackets. Ensure the cutout on the left underside of the log,
fi ts over the pilot assembly. Bend the bracket on the right side
to help retain the rear log.
2. Place the hole in the underside of log #2 onto the locating
screw, on the left side of the burner. The fi bre burner is formed
to cradle the centre of the log.
3. Place the hole in the underside of log #3 onto the locating
screw, on the right side of the burner. The bottom branch of
log #3 sits infront of, and against, the right end of log #2.
4. Reinstall the glass door & front.
LOG LOCATING SCREWS
FIGURE 33a-d
BRACKET