Napoleon Fireplaces GD80PT Indoor Fireplace User Manual


 
19
W415-0447 / B / 05.24.05
Glowing embers are NOT recommended. The burner has
been designed to achieve maximum glow without embers.
4. Place log #4, with the charred branch pointed inward.
Locate the pins into the holes in log#1 and log#2, this will
hold the rear log in position.
5. Place the end of log #5 on the right end of log #1. The fork
in the log should straddle the knot on top of log #2.
GLOWING EMBERS
BAFFLE INSTALLATION
CHARCOAL EMBERS
PHAZER
TM
logs, exclusive to Napoleon Fireplaces, provide
a unique and realistic glowing effect that is different in every
installation. The madison logs are fuel specific. Do not
interchange. Refer to the replacement parts list.
1. Place the rear log #1 onto the locating studs along the
back edge of the PHAZERAMIC™ burner.
2. Position log #2 onto the locators on the PHAZERAMIC™
burner.
3. Position the slot on the bottom of log #3 onto the bracket
shown with the charred face of the log to the front.
LOG PLACEMENT
Your fireplace has been supplied with the decorative brick
panels installed, however, it is necessary to install the fibre
baffle, on top of the side and rear panels.
Charcoal provided could be randomly placed on the fibre
hearth on both sides of the burner, and across the front, es-
pecially at the hearth joint.
Log colours may vary. During the initial use of the fire-
place, the colours will become more uniform as colour
pigments burn in during the heat activated curing pro-
cess.
Positioning the logs improperly will cause flame impinge-
ment and carboning.
Blocked burner ports can cause an incorrect flame pattern,
carbon deposits and delayed ignition. PHAZER
TM
logs glow
when exposed to direct flame. Use only certified PHAZER
TM
logs available from your Napoleon dealer.
1
2
3
4
5
BRACKET
FIGURE 40a-f
Note
For propane, remove the
screw from the #3 log support
bracket. Move the bracket to
the right most location, then
install the log.
Decorative brick panels must be installed before the logs.
See installation instructions supplied with the panel kit.