Napoleon Fireplaces GD82NT Indoor Fireplace User Manual


  Open as PDF
of 34
 
6
W415-0536 / C / 09.06.06
24"
16"
8"
Expansion / contraction nosies during heating up and cooling down cycles are normal and are to be expected. Change in

Do not use abrasive cleaners to clean plated parts. Buff lightly with a clean dry cloth. The glass is 3/16” ceramic glass avail-
able from your Napoleon / Wolf Steel Ltd. dealer. DO NOT SUBSTITUTE MATERIALS. 
DO NOT CLEAN GLASS
WHEN HOT! If the glass is not kept clean permanent discolouration and / or blemishes may result.
FIGURES 2A-C
Use only Wolf Steel, Simpson Dura-Vent, Selkirk Direct Temp
or American Metal Amerivent venting components.
Wolf Steel, Simpson Dura-Vent, Selkirk Direct Temp and
American Metal Amerivent venting systems must not be
combined.
Follow the installation procedure provided with the venting
components.

only the outer air intake joints must be sealed using a red high
temperature silicone (RTV). This same sealant maybe used
on both the inner exhaust and outer intake vent pipe joints
of all other approved vent systems except for the exhaust

be sealed using the black high temperature sealant Mill Pac.
A starter adaptor must be used and may be purchased from
the corresponding supplier:
 
Duravent W175-0053
Amerivent 4DSC-N2
Direct Temp 4DT-AAN
When using Napoleon venting components, use only ap-

following termination kits: WALL TERMINAL KIT GD222R, or
1/12 TO 7/12 PITCH ROOF TERMINAL KIT GD110, 8/12 TO
12/12 ROOF TERMINAL KIT GD111, FLAT ROOF TERMINAL
KIT GD112 or PERISCOPE KIT GD201 (for wall penetration
 in conjunction with the
various terminations, use either the 5 foot vent kit GD220 or
the 10 foot vent kit GD330. These vent kits allow for either

The maximum allowable vertical vent length is 40 feet
using exible venting. The maximum number of allowable 4”
vent connections is three horizontally or vertically (exclud-


keep the vent length and number of elbows to a minimum.
FIGURE 3
CARE OF GLASS, AND PLATED PARTS
   
 or NAPOLEON RIGID
OR FLEXIBLE

vENTING
vENTING LENGTHS & AIR TERMINAL
      
 or a 

a 
FIGURES 


  

















venting instruction exactly.
Deviation from the minimum vertical vent length can create

Provide a means for visually checking the vent connection to

Vent lengths that pass through unheated spaces (attics, ga-
rages, crawl spaces) should be insulated with the insulation
wrapped in a protective sleeve to minimize condensation.
The air terminal must remain unobstructed at all times. Ex-
amine the air terminal at least once a year to verify that it is
unobstructed and undamaged.
 previous next