Filter
Top Products
22
W415-0536 / C / 09.06.06
running and the gas valve turned to the “ON” position. Ensure
that the receiver has power and the backup switch is in the
auto position.
1. Install the batteries (AAA) into the remote control
transmitter. The “HOUSE” icon with room temperature will
be displayed.
2. Press the ON/OFF button on the remote. Icons
will appear at the same time and acoustic signal is
generated if not, move the transmitter closer to the re-
ceiver and repeat. If a signal is still not heard, it will be
necessary to execute the address setting procedure.
Note: There maybe a few seconds delay before the receiver
responds. Especially when using the wrought iron face-
plate.
3. Fahrenheit - Celsius temperature indicatior
It is possible to set the Remote Control transmitter to display
the temperatures in either Fahrenheit or Celsius. Use the UP
or DOWN button on the transmitter until the cursor (small
triangle) is left of the clock icon.
4. From time 0:00 press the LEFT key ten times. The display
will show the transmitter address. Use the RIGHT button to
toggle from °F to °C and vice versa. The display will show
the selected unit of measue. Press the LEFT button to exit
this function.
1. ON / OFF
2. FLAME HEIGHT
Check that the Remote Control is on, otherwise, turn on the
height until the cursor (small triangle) is to the left of the big
OPERATION / MAINTENANCE
FIREPLACE OPERATION
HAND HELD REMOTE OPERATIONS
(minimum) to 6 (maximum). An acoustic signal from the
3. AUTOMATIC CHANGE OF FLAME HEIGHT
The system is provided with three automatic sequences to
each sequence with an interval between one step and the
other of 5 seconds, for a total duration of 2.5 minutes. At the
end the sequence repeats continually until the sequence func-
tion is changed to an alternatate pattern or turned to off.
-
quences. Use the UP or Down button until the cursor (small
Use the left or right button to select sequence 1, 2 or 3. When
using the sequence function the room thermostat is active.
4. ROOM THERMOSTAT
The Remote Control can operate as a room thermostat.
To activate this function use the UP and DOWN key until the
cursor (small triangle) is left of the thermometer icon.
Then use the right of left button to set the desired room
temperature. (Figure 56)
This control system will cycle automatically the appliance on
or off to maintain the selected temperature.
FIGURE 53
FIGURE 54
FIGURE 55
TIME OUT
If the appliance is turned on and the Receiver does not receive
any command for 3 hours, it automatically turns the appliance
and the Remote Control off.
FIGURE 56