Napoleon Fireplaces GD82NT Indoor Fireplace User Manual


  Open as PDF
of 34
 
18
W415-0536 / C / 09.06.06
BLOWER
MOUNTING
PLATE
REMOVE 4 SCREWS
BLOWER REPLACEMENT
The Napoleon PARK AVENUE comes equipped with a heat
circulating blower. The blower is pre-wired and is controlled by
the remote control supplied with the unit. For control details,
see operation. Pg. 22.





1.
2. Turn off the gas valve.
3. Remove the glass door, logs, rear log supports, brick
-
port bracket.
4. The blower mounting plate can now be removed. Remove

5.
connectors before attempting to remove the blower from the

 Remove the two screws securing the blower and lift through
blower access opening.
FIGURE 37
REMOVE 2 SCREWS
Your PARK AVENUE comes equipped with our “Night Light”.
The light has been pre-wired and is controlled from the
remote control.
If in the event the lamp or lens needs to be replaced, follow
the instructions below.
Unplug the wireharness
/ transformer from the
junction box inside the

NIGHT LIGHT REPLACEMENT
SCREWS
LENSE
FRAME
FIREBOX TOP
FIGURE 40
Remove the four screws that secure the lens frame.
This frame retains the glass lens. The lamp can now be
accessed.
Note:

The lamp will pull straight out of the socket. Replace with
Wolf Steel parts only, as lamp and lens are special “high
temperature” products.
When re-installing, ensure integrity of gasket seal.





FIGURE 39
FIGURE 41
AMBER SIDE UP
GASKET
LENSE
FRAME
Note: When re-installing the replace-
ment blower, it will be necessary to
replace the gasket (W290-0104) on
the blower mounting plate.
FIGURE 38
 previous next