Filter
Top Products
25
W415-0210 / E / 06.25.03
INSTALLA-
TION TO BE DONE
BY A QUALIFIED IN-
STALLER and must
be electrically con-
nected and grounded
in accordance with lo-
cal codes. In the ab-
sence of local codes,
use the current CSA
C22.1 CANADIAN ELEC-
TRICAL CODE in Canada or the ANSI/NFPA 70 NATIONAL ELECTRICAL
CODE
in the United States
If the fireplace was not previously equipped with a
blower: route a grounded 2-wire, 60hz power cable to the
receptacle / junction box. At this point, it must be strain
relieved and insulated.
The three slots on the
blower mounting
bracket allow ease of
adjustment when
attaching the blower.
For a quiet running
blower, do not allow the
assembly to sit on the
firebox base.
Slide the vibration reducing pad (A) into the clip (C) and up
against the threaded stud (B) at the other end. The blower
must be able to be positioned entirely onto the pad.
To ease installation of the blower, remove the hinge screen
and valve control door (lower louvres) from the base of the
fireplace.
Tilt the blower onto its side. Slide it past the controls and
into the clip (C). Secure to the threaded stud using the lock
washer and wing nut provided. Ensure that the blower
does not touch the fireplace base or the firebox.
r
e
d
w
h
i
t
e
b
l
a
c
k
FIGURE 48
SLOTS
ELONGATED
FIGURE 49
Attach the connectors
from the black and white
wires to the thermodisc
and secure the
thermodisc bracket to the
securing stud at the bot-
tom left of the unit using
a lock washer and wing
nut. Ensure that the
thermodisc touches the
firebox wall.
Attach the connectors
from the black and red
wires to the blower.
Attach and secure the variable speed switch using the nut
provided. Plug the harness cord into the receptacle.
The wire harness pro-
vided in this kit is a uni-
versal harness. When in-
stalled, ensure that any
excess wire is con-
tained, preventing it
from making contact
with moving or hot ob-
jects.
Because the blower is thermally activated, when
turned on, it will automatically start approximately
10 minutes after lighting the fireplace and will run
for approximately 30-45 minutes after the fire-
place has been turned off. Use of the fan increases
the output of heat.
Drywall dust will penetrate into the blower bear-
ings, causing irreparable damage. Care must be
taken to prevent drywall dust from coming into
contact with the blower or its compartment. Any
damage resulting from this condition is not cov-
ered by the warranty policy.
RECEPTACLE
/
THERMODISC
GROUND
SCREW
JUNCTION
BOX
FIGURE 52
FIGURE 53
C
A
B
FIGURE 51
FIGURE 50
OPTIONAL BLOWER INSTALLATION