Filter
Top Products
22
PROGRAMMING USER CODES
Your Installer has programmed into your system a special User Program Code which can be used to not only Arm and Disarm
the system, but also to enter the User Program Mode, where you can program other User Codes. The following explains how
you will use this code to program or erase additional User Codes.
Entering the User Program Mode
1 Enter your User Code, then press R to enter the Function Mode.
2 Answer NO (press Q ) until “17” (Activate Program) is displayed, then press YES (P) .
The display will scroll the following: “P” (Program mode); 4 digits identifying software versions; then “UP” (User Program).
The keypad sounder will beep while in the User Program Mode.
Programming / Reprogramming a User Code
1 Press R, followed by the the 2 digits of the user number to be programmed ( Example: for User 4, enter 04).
2 Press R, followed by the new User Code (up to 6 digits).
3 Press R repeatedly until “UP” is displayed.
4 Press U to save the new User Code. Note: Duplicate Codes are not allowed; therefore a duplicate Code entered in the
LCD Window will erase when
U is pressed. Repeat Steps 1 through 4 for each User Code to be programmed.
Erasing a User Code
To erase a User Code, press R, the 2-digit user number, R followed by G0 until “UP” is displayed, then U.
• Example: Erase User 3’s User Code:
Press
R03RG0G0G0G0G0G0 (“UP” will display) U
Reviewing a Programmed User Code
To review a User Code, press R, the 2-digit user number and R to step through and review each digit of code.