Filter
Top Products
30
C. LIGHTING INSTRUCTIONS
FOR YOUR OWN SAFETY READ BEFORE OPERATING
1. This appliance does not have pilot. It is equipped with an ignition device which automatical-
ly lights the burner. Do not try to light the burner by hand.
2. BEFORE OPERATING smell all around the appliance area for gas. Be sure to smell next to the
floor because some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do not use any phone in your building.
• Immediately call your gas supplier from a neighbor's phone. Follow the gas suppliers'
instructions.
• If you cannot reach your gas supplier, call the fire department.
3. Turn on gas shutoff valve (located inside of the Heater) so that the handle is aligned with the
gas pipe. If the handle will not turn by hand, don't try to repair it, call a qualified service tech-
nician. Force or attempted repair may result in a fire or explosion.
4. Do not use this appliance if any part has been under water. Immediately call a qualified serv-
ice technician to inspect the appliance and to replace any part of the control system and any
gas control which has been under water.
5. The Munchkin Heater shall be installed so the gas ignition system components are protected
from water (dripping, spraying, rain, etc.) during appliance operation and service (circulator
replacement, condensate trap, control replacement, etc.)
D. OPERATING INSTRUCTIONS
1. STOP! Read the safety information in Part 6.
2. Turn off all electric power to the appliance.
3. This appliance is equipped with an ignition device which automatically lights the burner. Do
not try to light the burner by hand.
4. Remove front cover.
5. Turn gas shutoff valve to “off” position.
6. Wait five (5) minutes to clear out any gas. If you then smell gas, STOP! Follow Part 6, Section
B/Lighting Instructions in the safety information. If you don't smell gas, go to the next step.
7. Turn the gas shutoff valve to “on” position.
8. Replace the Front Cover.
9. Turn on all electric power to appliance.
10. Set the temperature to the desired setting.
11. If the appliance will not operate, follow the instructions “To Turn Off Gas To Appliance”
Section E and call your service technician or gas supplier.
E. ADJUSTING THE OPERATING SET POINTS OF THE MUNCHKIN VWH DISPLAY
To adjust a set point value on the Munchkin VWH, Simply press the S3/Program key for three sec-
onds until you see dd then an alternating value of 119° F. This will be your first function. To advance
to the next function, simply press the S3/program (see set point adjustment chart on next page).
Any function setting may be changed by pressing either the S1/- or the S2/+ key on the display.
After advancing through the function, press the S3/Program key, this will bring you back to normal
operation, displaying the output temperature of the Munchkin VWH.
START-UP PROCEDURES