Filter
Top Products
9
9
4 Squeeze out excess water and allow to air-dry
for at least 24 hours before replacing. Do not
use a hair dryer or other heating methods to
dry.
5 Replace the felt filter in first, then the foam
filter.
6 Replace the dust canister.
Exhaust filter
(to be cleaned at least every six months)
1 Remove the filter cover Q.
2 Take out the HEPA filter by pulling it straight
out.
3 Turn the filter over so that the dirty side is on
the bottom and vigorously tap it clean over a
dustbin to remove any dust R.
4 Wash the filter under the tap using lukewarm
water with the dirty side face down until the
water runs clear S.
5 Allow the filter to air dry for 24 hours. Do not
use a hair dryer or other heating methods to
dry.
6 Once the HEPA filter is dry, replace it back into
the vacuum cleaner.
7 Replace the cover by inserting the two tabs
into the holes at the top and then swinging the
cover down until it clicks into place.
NOTE: The material in the filter will discolour
over time. This is normal and will not affect the
performance of the filter.
Hose blockages
The hoses
¤ Ô
may be detached and
inspected by pulling out connections or
squeezing the tabs together and pulling up
where applicable T.
Straighten out the hoses and look inside for
blockages. Also inspect inside the suction
ducts on the vacuum cleaner.
Cleaning the motorised floor
brush
1 Press the On/Off 3-position switch ‰ to the
“O” position to turn the vacuum off and unplug
the power cord from the mains outlet.
2 Separate the Lift Away canister
˜
from the
motorised floor brush nozzle
by pressing
the
Lift Away canister release button Ï
H1
on the side of the Lift Away canister, then
gently hold the motorised floor brush nozzle to
the floor with your foot H2 and pull the Lift
Away canister up.
3 Turn the motorised floor brush over to inspect
the rotating brush bar
Ú
and pull away any
hairs or fibres. If they are tightly wound around
the brush, carefully snip the fibres with
scissors U, being careful not to damage the
rotating brush bar, pull away from the rotating
brush bar and dispose of.
For details of other Morphy Richards products, please see our website:
Rotating
Brush
U
S
Q
R
T
VC73410MUK Rev2_Instruction Booklet 11/03/2011 11:00 Page 9