Filter
Top Products
25
Product Operation
Before You Start
Check the following before you start the RYDIS H68 Pro.
1
Be careful not to break the RYDIS H68 Pro when you pull the RYDIS H68 Pro out of the box.
For information of installing the RYDIS H68 Pro, see page 16.
2
Check the location (L/R) of the brushes and install them.
For information on installing the brushes, see page 17.
3
Pull the RYDIS H68 Pro out and manually charge it fully rst.
When you start the RYDIS H68 Pro for the rst time, it may not work, as the battery has probably been
discharged. For information on manual charging, see page 23.
4
Remove any obstacles on the oor.
Remove small objects, clothes, and fragile objects from the oor before cleaning. Fold up lengthy carpet/rug
tassels or keep the RYDIS H68 Pro away from them.
5
If the dust bin is full, the cleaning performance will be reduced. Emptying the dust bin frequently is highly
recommended.
For information on cleaning the dust bin, see page 40.
6
If there is anything on cli detection sensors or wheels, remove it.
This may cause failure or malfunction of the RYDIS H68 Pro. For information on cleaning cli detection
sensors and wheels, see page 42.
7
Children and seniors may be surprised at the sight of the RYDIS H68 Pro in operation.
Please let children and seniors know about the operation of the RYDIS H68 Pro.
8
Be careful not to drop the RYDIS H68 Pro from a high place.
Do not use the RYDIS H68 Pro on a narrow or a high place such as a desk, table, etc. If shoes are placed side by side at
the entrance to the living room, the RYDIS H68 Pro may recognize them as the oor, which may cause falling.
9
For safety reasons, the RYDIS H68 Pro was designed not to climb over a threshold higher than 0.4 inch (1cm).
For less than a 0.4inch threshold height, the user is able to choose threshold climbing over on/o option by the remote
control. We recommend not to climb over while in Mop Cleaning mode and Hybrid Cleaning mode due to the Big Mop
with the H2O Tank. We also recommend that you select the Threshold Option (climb over) ON while in Vacuum
Cleaning mode. Factory default is set to not climb over for Hybrid, Vacuum and Mop Cleaning mode. See page 26~29.
10
After charging is complete, keep the RYDIS H68 Pro docked in the charging station, or turn the system
power switch o which is located on the rear side of the RYDIS H68 Pro.