42D0200
Designer Series Gas Fireplaces
31
1. Remove glass frame. Refer to Glass Frame Removal, Page 31.
2. Carefully remove logs from wrapping.
3. Place left log (#1) on left end of grate. Line up two (2) pin holes in bottom of log with two (2) pins
on grate. Log #1 will always be to the left of the control panel. Figure 41
4. Place right log (#2) on right end of grate. Line up three (3) pin holes in bottom of log with three
(3) pins on grate. Figure 42
— This unit is supplied with eight ceramic fiber logs. Do not handle these logs
with your bare hands. After
handling the logs, wash your hands gently with soap and water to remove any traces of fibers.
LG639
DV6000 right log
Figure 42 -
Install Right Log (#2)
Right Log
(#2)
Pins
Control Panel
LG638
DV6000 left log
Figure 41 -
Install Left Log (#1)
Left Log
(#1)
Grate
Pins
Control Panel
LG638