Filter
Top Products
36
MSZ-FD09NA MSZ-FD12NA
NOTE :Turn OFF power supply before disassembling.
OPERATING PROCEDURE
PHOTOS
1. Removing the panel
(1) Hold both sides of the front panel and lift the front panel
until it is level. Pull the hinges forward to remove the front
panel.
(2) Remove the horizontal vanes.
(3) Remove the screw caps of the panel. Remove the screws.
(See Photo 1)
(4) Hold the lower part of both ends of the panel and pull it
slightly toward you, and then remove the panel by pushing
it upward.
DISASSEMBLY INSTRUCTIONS
10
(1) Slide the sleeve and check if there is a locking lever or not.
(2) The terminal with this connector has the
locking mechanism.
Slide the sleeve.
Pull the terminal while
pushing the locking
lever.
Hold the sleeve, and
pull out the terminal
slowly.
Connector
Sleeve
Locking lever
Photo 1
Screws of the panel
Front panel
Horizontal vane
<"Terminal with locking mechanism" Detaching points>
The terminal which has the locking mechanism can be detached as shown below.
There are two types (refer to (1) and (2)) of the terminal with locking mechanism.
The terminal without locking mechanism can be detached by pulling it out.
Check the shape of the terminal before detaching.