Filter
Top Products
34
OPERATING PROCEDURE PHOTOS
Photo 13
Photo 11
Photo 12
Front panel
driving motor
Screw of the plasma
element holder
7. Removing the plasma power P.C. board
(1) Remove the horizontal vane, the panel (Refer to 1.) and
the corner box.
(2) Remove the switch holder and the electrical cover.
(Refer to 3.)
(3) Disconnect the connector of the front panel driving motor
<CN1U1> from the electronic control P.C. board.
(4) Remove the front panel driving motor.
(5) Remove the screw of the plasma element holder, and remove
the plasma element holder from the heat exchanger.
(See Photo 11.)
(6) Unhook all the catches of plasma unit cover and remove
the plasma unit cover. (See Photo 12.)
(7) Remove the terminals with locking mechanism connected
to the plasma power P.C. board and the safety device
(Plasma unit). (See Photo 13.)
(8) Remove the plasma electrical box from the plasma element
holder.
(9) Remove the screw fixing the plasma electrical box, and
open the plasma electrical box then pull out the plasma
power P.C. board from the plasma electrical box.
(See Photo 13.)
Plasma unit cover
Terminal
Screw of
the plasma
electrical box
Terminal
Safety device
(Plasma unit)
Terminal
Terminal
Plasma
power
P.C. board
OB371_--2qxp 05.1.17 12:49 Page 34