Filter
Top Products
Truck Mount Forage Boxes
Depending on the make and model of truck it may be necessary to install a light converter (MEYER PART #56-0028.)
Converter will allow signal lights and brake lights to operate according to DOT lighting standard. Call factory for more
information.
3200 & 4200 Series -- 11 –
COUPLING PLATE
(Shield Removed For Illustration Purposes Only)
SLEEVE SPACER
QUILL
ZERK
(Shield Removed For Illustration Purposes Only)
STEP 1
Install Coupling Plate and lynch pin onto the large gear
-
box assembly, splined shaft at the FRONT
of the forage
box.
STEP 2
IMPORTANT! (MUST PERFORM)
Install sleeve spacer and lynch pin onto the hydraulic
drive gearbox atthe REAR
of the foragebox. The internal
splined shaft willbe idling in reverse and thegearbox quill
zerk must be greased daily.
FRONT UNLOAD DRIVE COUPLER “SET-UP”
(PTO OR HYDRAULIC DRIVE)
WARNING: DISCONNECT PTO DRIVE SHAFT AND HYDRAULIC HOSES (RELIEVE HYDRAULIC PRES
-
SURE) BEFORE CLEANING, ADJUSTING, LUBRICATING OR SERVICING THIS FORAGE BOX. FAILURE TO
HEED MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH.
WARNING: DO NOT OPERATEWITHOUT ALL SHIELDS, GUARDS AND COVERSINSTALLED. FAILURE
TO HEED MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH.