Filter
Top Products
Mercur
y
6-5 Stat
–
Installation & User Guide
Installation:
Panel Cut-out:
72mm
93mm
34mm
17mm
2 holes: 3.5mm dia.
Fixing:
The controller can be fixed either by 2 X M3 screws from the rear or by the plastic retaining device (PR0329),
obtainable from RDM.
Clearances:
The controller must have 5mm clearance above the top and below bottom, and 25mm clearance from the
sides. Clearance at the rear is dependant on the wiring.
There is no requirement for forced cooling ventilation
Ensure that all power is
switched off before
installing or maintaining
this product
Revision 1.2 Page 18 of 21