Operation 25
Travis Industries 100-01142 4050114
Adjusting the Blower Speed (optional)
The blower helps transfer the heat from the heater into the room. It will not turn on until the heater is
up to temperature (approximately 10 minutes after starting). See the illustration below for instructions
on adjusting the blower speed.
OFF
Turn the dial all the
way counter-clockwise
until it clicks off.
HIGH
The high position
is all the way
clockwise.
LOW
Turn the dial all the
way counter-clockwise,
without clicking off.
Normal Operating Sounds
Gas Control Valve
As the gas control valve is turned
on and off you will hear a dull
clicking sound. This is the valve
Blower Snap Disk
This part can produce a clicking sound as
The appliance may creak with change of
temperature -- THIS IS NORMAL.
Pilot Flame
The pilot flame,
which remains on,
makes a very slight
"whisper" sound.
Blower
This heater uses a blower to push heated
air into the room. You will hear the sound
of air movement that increases as the
speed is increased.
Extinction Pops
It is not unusual, especially on Propane
(LP) appliances, to experience a "pop"
when the burner is shut off.
Normal Operating Odors
This appliance has several areas that reach high temperatures. Dust or other particles on these areas
may burn and create an odor. This is normal during start-up. You may notice the smell is more acute if
the appliance was left idle for a long period.
