Filter
Top Products
20 Operation
Travis Industries 100-01135 4040809
Safety Notice
Read this entire manual (especially the “Safety Precautions” on pages 4 and 5)
before using this stove. Failure to follow the instructions may result in property
damage, bodily injury, or even death.
Location of Controls
PILOT
IGNITER
Blower
Control
Gas Control Valve
Gas Control Knob
Flame Adjust Knob
The pilot flame is located
below the rear log.
ON/OFF Switch
The on/off
switch is
located on
the back of
the heater.
O
F
O
N
F
On/Off Switch This control is used to turn the main burner on and off.
Gas Control Knob This knob is used to control gas to the heater and for starting the pilot.
There are three positions, ON, OFF, & PILOT. The pointer to the left of
the knob indicates the position this knob is in.
Flame Adjust Knob This knob controls the flame height from low (“LO”) to high (“HI”). The
pointer above the knob points to the position this knob is in.
Pilot Igniter The pilot igniter is used only to start the pilot. When pressed, it sends an
electrical charge to the pilot assembly. This creates a blue spark directly
next to the pilot, igniting the pilot flame.
Blower Control This knob controls the speed of the internal convection blower that
pushes the heated air into the room.
? If using a remote control or thermostat, the On/Off Switch must be left “ON”. Turning the On/Off
Switch “OFF” will keep the heater off always.