Filter
Top Products
10 Installation (for qualified installers only)
Travis Industries
100-01135 4040809
Approved Vent Configurations
Restrictor Position
• A vent restrictor is built into the appliance to control the flow rate of exhaust gases. This ensures
proper flames for the wide variety of vent configurations. Depending upon the vent configuration, you
may be required to adjust the restrictor position. The charts for approved vent configurations describe
which position the vent restrictor must be in.
The restrictor is located
directly above the door,
behind the grill.
To Adjust the Restrictor:
To Access the Restrictor:
1
2
Determine the correct restrictor position (see the charts under
"Approved Vent Configurations" - the factory position is #1).
Lift up the adjustment plate and move it so the correct notch
falls into the slot on the adjustment bracket.
This restrictor is in position 1
(factory setting).
This restrictor is in position 7.
Adjustment
Bracket
To adjust, lift up on the
adjustment plate and
push it back.
WARNING: Use a glove to protect
your hand from burns.
Adjustment
Plate
# 8
# 7
# 2
etc.
Measuring Vent Lengths
Vent
Horizontal
Run
Vent Horizontal Run is
measured from the start of
the horizontal section to the
end of the termination.
Vent Height is calculated to
the top of the vent on
horizontal terminations and
to the top of the termination
on vertical terminations.
Vent
Height
Vertical Elbow
NOTE:
When a horizontal elbow (90° or 45°) is
used, horizontal length is the sum of the
two lengths (H1 + H2).
H1
H2
Horizontal
Elbow
Vertical Elbow