Filter
Top Products
Maintenance 31
Travis Industries 4061016 100-01184
Bi-Weekly Maintenance (or every 10 bags of pellets) - continued
Clean the Baffles
WARNING : Make sure the heater has fully cooled (approximately 25 minutes) before conducting service.
HINT : The more often you clean out flyash, the more efficient your heater will burn.
The baffles are found along the top of the firebox. The front edge has a slot that slides into a hook on
the top of the firebox. The back rests on the back refractory. To remove, slide them inwards, pull
them forward, and tilt them back to allow the accumulated flyash fall off into the firebox. Replace after
cleaning.
Push up on the front portion of the left
baffle and slide it to the right. Note how
the rear edge of the baffle rests on the
rear refractory.
Move the baffle forward and tilt the back down.
This allows any built-up flyash to fall off the top
of the baffle.
The right side baffle is removed
in the same fashion. Note how
the right side baffle is larger
than the left side baffle.