Filter
Top Products
1 Service
12
Service Manual
Parameter table
Table 1D This table lists SMART SYSTEM control module parameters and where to access them
MENU SUB ITEM DESCRIPTION
SEE
PAGE
USER ACCESS INSTALLER ACCESS
DISPLAY MODIFY DISPLAY MODIFY
A
1 Boiler Model 13 Yes No Yes No
2 User Code 13 Yes Yes Yes Yes
3 Date and Time 13 Yes Yes Yes Yes
4 Software Version 13 Yes No Yes No
5 Temperature Units 13 Yes Yes Yes Yes
6 Night Setback Temperature 13 Yes Yes Yes Yes
7 Night Setback Times 13 Yes Yes Yes Yes
GENERAL
C
1 Total Hrs. Run 13 Yes No Yes No
2 Ignition Attempts 13 Yes No Yes No
3 Show Last 10 Errors 13 Yes No Yes No
D
1 Reset Last 10 Errors 13 No No Yes Yes
2 Service Mode Delay 13 No No Yes Yes
DATA
FUNCTIONS
E
3 Tank Set Point 14 Yes Yes Yes Yes
LOGGING
WHR
SETTINGS
The parameters for Building Management System operation are not listed in this table. They are only accessible using the
PC interface software. See separate documentation for access information. See page 14 of this manual for a brief discussion.
NOTICE
H
2
Control Source (Thermostat, BMS,
and Cascade)
14 No No Yes Yes
3 Cascade Address 14 No No Yes Yes
4 Max. Cascade Set Point - Not Used 14 No No Yes Yes
5 Cascade Offset - Not Used 14 No No Yes Yes
6
Cascade Off-On Differential - Not
Used
14 No No Yes Yes
CONTROL
MODES
I
3 WHR Pump Delay 15 No No Yes Yes
CIRCULATION
PUMPS
J
1 Service Notification in Month 15 No No Yes Yes
2 Service Notification Running Hours 15 No No Yes Yes
3 Service Notification Cycles 15 No No Yes Yes
4 Reset Service Notification Counter 15 No No Yes Yes
SERVICE
NOTIFICATION