Filter
Top Products
Prince XL
®
- Owner's Manual - Page 3
SECTION A INSTALLATION
TECHNICAL SPECIFICATIONS
PRINCE
®
XL TORCH - 25’- P/N K2296-2
Wire Capacity
• .023”-.045” (0.6 - 1.2mm)
solid and hard wire
• .030” - 1/16” (0.8 - 1.6mm)
aluminum and cored wire
Wire Speed
• 750 ipm (19.0 mpm) max.
Duty Cycle - 100%
All ratings are at 25V using Argon Gas
• 200 Amps Air cooled standard, using Air/Water barrel
Torch weight (less leads & standard barrels)
• 36.4 oz. (1.02 kilogram)
P
RINCE
®
XL SPOOL GUN - 25’ - P/N K2297-2
Wire Capacity
• .023” - .045” (0.6 - 1.2mm)
solid and hard wire
• .030” - 1/16” (0.8 - 1.6mm)
aluminum and cored wire
Wire Speed *
• 750 ipm (19.0 mpm) max.
Spool Size
• 4 inches (101.6mm)
Duty Cycle - 100%
All ratings are at 25V using Argon Gas
• 200 Amps Air cooled standard, using Air/Water barrel
Torch weight (less wire & leads)
• 46.5 oz (1.3 kilogram)
* Maximum ipm varies depending on input voltage, wire size
and the control box used.
SUPPORT EQUIPMENT REQUIRED
• CV or CC power source of suffi cient capacity for your needs.
• Regulated gas supply and hoses.
• Properly sized power leads from power source to wire feeder and
ground.
TORCH LEAD CONNECTIONS
POWER CABLE - AIR COOLED
A #2 AWG power cable is used on the Prince
®
XL air cooled torch. The torch
end is threaded into the torch body. The power cable fi tting connects to the
Power Block.
(MK P/N 003-1674) when using a Cobramatic
®
wire feed cabinet. When the
Prince
®
XL is purchased as a Spool Gun, the power cable comes standard
with a lug connector and should be connected to positive lug of power supply.
CONDUIT
The Prince™XL Torch comes standard with a poly lined conduit, for running
aluminum wire. The longer fi tting with a shallow groove is used on the torch
end. A set screw located on top of the torch handle secures the conduit in