Filter
Top Products
506052−01 11/09
Page 14
Tests − Page 1 of 1
The tests feature is not available until after setup has been completed
once. After you press next step in the final setup screen, the Select
tests to run" screen (figure 18) appears.
If you re−select the tests tab from any other screen, a message to press
Start button below to begin system testing" appears; press start.
setup tests equipment HELP
selected tests
select tests to run
select
TEST ALL
Blower
HP Heat − 1st
Stage
HP Heat − 2nd
Stage
Defrost Now
Cooling − 1st
Stage
Cooling − 2nd
Stage
skip tests
press start button below to begin system testing
start
alerts diagnostics EXIT
Figure 18. Select tests to run
When the tests screen opens, TEST ALL will be highlighted (but not yet
selected). If you want to run TEST ALL, press select. Note your selection
on the right side says selected test TEST ALL". Also, note there are now
two buttons along the bottom labeled remove and start. Use remove to
deselect a selected test.
If you prefer, run tests one−at−a−time using the arrows to highlight a de-
sired test and then press select.
Press start to begin testing.
setup tests equipment HELP
selected tests
TEST ALL
select tests to run
select
TEST ALL
Blower
HP Heat − 1st
Stage
HP Heat − 2nd
Stage
Defrost Now
Cooling − 1st
Stage
Cooling − 2nd
Stage
startremove
alerts diagnostics EXIT
Figure 19. Start running tests