Filter
Top Products
Operating the Seamless Switcher / Scaler
13
7 Operating the Seamless Switcher / Scaler
Section 7.1 describes how to switch and scale an input. Section 7.2 describes
the methods of controlling the Seamless Switcher / Scaler.
7.1 Switching and Scaling
Section 7.1.1 describes how to switch an input. Section 7.1.2 describes how
to select the output resolution.
7.1.1 Switching an Input
You can switch seamlessly
1
between each input
2
that is connected to a source,
by pressing the appropriate INPUT SELECTOR button. The OSD status
appears superimposed over the top right corner of the screen for a few
seconds
3
, as Figure 6 illustrates:
Figure 6: OSD Input Status
You can also use the INPUT SELECTOR button to freeze
4
the image or to
display a blank screen
5
.
7.1.2 Choosing the Output Resolution
You can select the output resolution (choosing the pixel resolution, as section
6.1 describes), by pressing the OUTPUT MODE SELECT button
6
on the
front panel or the OUT key on the infra-red remote control transmitter (see
1 For glitchless transitions between inputs
2 To set the image transition speed (fast, safe or moderate), see section 7.3.6.4
3 By default, 20 seconds. But you can reset the timeout (from 3 to 60 seconds), see section 7.3.6.5
4 By pressing the INPUT SELECTOR button again when the appropriate LED illuminates
5 By pressing the INPUT SELECTOR button once again when the appropriate LED flashes
6 Item 16 in Figure 1