Filter
Top Products
16
2.3 Mark the positions of the fixing screw
holes on the wall.
2.4 For solid walls drill two 6 mm holes for
the wall plugs.
2.5 Fit the wall plugs (supplied) and fix the
shower valve to the wall with the
securing screws (supplied).
Note! For stud partition installations
alternative fixings may be required (not
supplied) to fix the shower valve to the
rear face of the wall cavity or to a
timber noggin.
Important! At this point position the
building-in shroud onto the shower
valve and make sure that it is level,
both horizontally and vertically.
2.6 Refer to section: ‘1. Solid Wall or
Stud Partition Installation (Using
Securing Brackets - Mounting off
Front Face)’ and follow instructions 11
to 18.
Hot Supply
Cold Supply
Outlet Pipe
to Fittings
Securing
Screw