Filter
Top Products
22
CFI230J
7
CFI230J
Check the wall channel is vertical and mark
through the 3 holes ‘A’
A
Drill 3 x 6mm holes
Fit plugs
Loosely fit screws
A
Seal behind channel
and tighten screws
A
B
STEP
5
STEP
6
STEP
7
STEP
8
Slide glass panel into slot in tray “A’ and fit
jamb onto wall channel ‘B’
On the inside of the enclosure. pull the rubber
strip away from the wall jamb
Fit the splash guard to the bottom of the panel.
Note: lip faces to the outside of Enclosure
and cutout is towards the wall end of the glass
Lift the glass door up and slide the rollers onto
the lintel
Caution
Loosen the screw fixing the bottom roller to
the glass with a 3mm allen key
Locate other side of glass door panel between
the roller and plastic glass guide
Caution
Whilst supporting the weight of the door slide
the bottom roller into the bottom track
Caution
STEP
32
STEP
33
STEP
31
STEP
30