Filter
Top Products
- CARE OF YOUR REVERSE OSMOSIS SYSTEM -
TUBING CONNECTION (continued)
If tubing other than tubing supplied with the system
is used, be sure it is of high quality, exact size and
roundness with a smooth surface.
AUTOMATIC SHUTOFF SERVICE
If the shutoff assembly requires service, be sure to
reassemble parts exactly as shown in FIG. 12, and to
reconnect tubing as shown on pages 10 and 16.
To Disconnect Tubing: Push the collet inward and
hold with a finger while pulling the tubing out.
FIG. 11 ]
cut tubing s_uare
' -7
I
k_ ....
I I
I
end of tubing round and
smooth, with no cuts,
nicks or flat spots
Tubing correctly cut and connected
collet ..._ [_
11116" (1/4" tubing
' engagement
r11- 3/4. (3/8. tubing)
tubin
collet (depress to
remove tubing)
Replacing collet end
o-ring seal
Push o-ring seal into
bottom of port, then
follow with collet.
tting
collet
Changing CoUet and O-ring (FIG. 11):
1. With a small screwdriver remove the collet and o-
ring from the fitting.
2. Be sure the port is clean, then lubricate and insert
the o-ring seal to the bottom of the port.
3. Push the coUet inward until it locks in place.
r Bm.._
I CAUTION I
I DO NOT USE VINEGAR OR OTHER ACID I
I BASEDCLEANERSONTHISROSYSTEM. THEY I
I WILL DEGRADE SOME RO SYSTEM PARTS. AL- I
[ WAYS USE SOAP AND WATER. I
t 1
I This reverse osmosis system contains a replaceable I
] treatment component critical for effective removal I
I of total dissolved solids. The water should be [
I tested periodically to verify the system is perform- I
[ ing satisfactorily. [
I- ........ -I
FIG. 12 ]
screw (4)
SHUTOFF
ASSEMBLY
f<_>_ Tee Fitting,
./ 1/4" NPT x 3/8"
_- _ Tube
diaphragm O
plunger (_
diaphragm O
Elbow fitting turns__/_'_
int° OUT P°rt'_ _, Male Connector,
,, _ / 1/8"NPTxl/4"Tube
Male Elbow, I/8 _ ..._... /
.PTx 1/4"Tob+ng
J collet
13