Filter
Top Products
SECTION 1 WATER SOFTENER START-UP
I
1C. PROGRAM THE TIMER
signal light adjust
f
salt level adjust
Kenmore Water Line
for Customer Assistance
1-800-426-9345
display
\
_ RECHARGE TONIGHT
LOW RECHARGE NOW
SALT
/
ON/OFF-HOLD button
(Recharge Tonight-Now)
UP button SELECT button
DOWN button
High Flow
Deluxe Demand Water Softener
with Dual Segment Electronic Display
When the transformer is plugged in, the model
code HF31, and a test number (example: k11) show
in the face plate display for 4 seconds. Then, 12:00
AM and PRESENT TIME begin to flash.
I/
,, II
I -I,NN _=
IC'LILI
PRESENT TIME
NOTES:
If SR - - shows in the display, press the UP [] or
DOWN [_button until HF31 shows. Then, press
the SELECT button to set, and change to the flash-
ing PRESENT TIME display.
To check the model code, unplug the transformer
at the wall outlet and plug in again, if other than
HF31 shows, see page 18 to reset.
SOUND "BEEPER": A "beeper" sounds while
pressing buttons for timer set-up. One beep signals
a change in the face plate display. Repeated beeps
mean the timer will not accept a change from the
button you have pressed, telling you to use another
button. For example, while setting the hardness
(step 2), the beeper sounds repeatedly when the
display reaches I using the DOWN button, or the
highest hardness setting using the UP button.
1. SET PRESENT TIME OF DAY:
NOTE:
If the words PRESENT TIME do not show in the
display, press the SELECT button (FIG. 1) until
they do, or see the previous notes.
• Press the UP / DOWN buttons to set the present
time. Press UP to move the display ahead; press
DOWN to move the time backward.
If the present time is between
noon and midnight, be sure PM
shows.
I I,C r'[ PM
q,_-II_-I
PRESENT TIME
I h-I_ _M
i i,_70
PRESENT TIME
If the present time is between
midnight and noon, be sure AM
shows.
NOTE:
Each press of the UP/DOWN buttons changes the
time by i minute. Holding the buttons in changes
the time 32 minutes each second.
6