Kenmore 625.34859 Water System User Manual


 
SECTION 2 .ow YOUR WATER SOFTENER WORKS
I I
2B. FACE PLATE TIMER FEATURES
EXTRA RECHARGE
Sometimes, a manually smrte(t regeneration (re-
charge) may be desired, or needed. Two examples
aye:
--You have used more water than usual (guests
visiting) and you may run out of soft water before the
next timer started regeneration.
--You did not refill the softener with salt before it
was gone.
You can start a regeneration right away, or you can
set the timer to regenerate at the next 2:00 AM (or
other preset recharge time). Do the following.
RECHARGE NOW
Press the ON/OFF-HOLD
button and hold until "RE-
CHARGE, Sen_ and Fill begin to
flash in the display. Upon
reaching fill, the first cycle of re-
generation, the flashing Se_¢_
IOFF Se_
n, --I,1-11-1Pv
H_.--J
RECHARGE
WATERFLOW
goes off and Fill is on steady. _CHARGE contin-
ues to flash. This regeneration will last for about 2
hours. After the 2 hours, you will have soft water
again.
"NOTE:
If the CLEAN feature is set to ON, a cleaning
backwash (dZEAN and Blew,sO orRinse flashes in the
display, along with the minutes of the clean cycle
remaining) precedes the recharge.
RECHARGE TONIGHT
Press and release (do not
hold) the ON / OFF-HOLD but-
ton. I_,CtIARGE TONIGHT
flashes in the display, and the
softener begins regeneration at
the next preset recharge time.
ion q f-Ii-I PMi
,uo I
RECHARGE TONIGHT
I
Press and release the ON/OFF-HOLD button once
more if you decide to cancel the regeneration, and
_CHARGE TONIGHT.
SALT MONITOR SYSTEM
The face plate timer has a low salt monitor with an
indicator light to remind you to refill the storage tank
with salt. To set this monitor system:
le
2s
IJft the salt hole cover and level the salt in the
storage tank.
The salt level decal, on the brinewell inside the
tank, has numbers from 0 to 8 (see drawing on
page 9 and below). Observe the number the
leveled salt is at or closest to.
3e
4s
Now, press the SALT LEVELADJUST button until
black bars display up to the salt level number. For
example, the pictures below show the salt level
at 6.
Finally, set the level you want the low salt
indicator light to come on. Press the SIGNAL
LIGHT ADJUST button until a (g) shows
opposite this number. In the example below, the
light will come one when the stored salt drops to
level 2. At level 2, the storage tank is about 1/3
full. This is the lowest you should allow the
stored salt level to drop to. To turn the salt
monitor off, press the button until OFF shows.
NOTE:
For accurate salt monitor operation, always use
nugget or pellet water softener salt. See page 9.
salt
level
10