Filter
Top Products
OBSERVEALL LOCAL CODESAND ORDINANCES.
DO NOT,UNDERANY CIRCUMSTANCES,REMOVE
THE POWERSUPPLY CORDGROUNDPRONG.
ELECTRICAL GROUNDISREQUIREDONTHIS
APPLIANCE.
For 230/208volt 60 Hz, AConly, 15Afusedand
properlygroundedelectricalsupply is required A time
delayfuse or time delay circuitbreakeris
recommended Usea dedicatedcircuit,serving only
this appliance.
DO NOTUSE AN EXTENSIONCORD.
115V~
F
230V ~
RECOMMENDEDGROUNDINGMETHOD
Foryourpersonalsafety,thisappliancemustbegrounded.
Thisappliancehasa powersupplycordwitha 3-prong
groundingplug.To minimizepossibleshockhazard,the
cordmustbepluggedintoa matinggroundingtypewall
receptacleandgroundedinaccordancewiththe National
ElectricalCode(ANSI/NFPA70)latesteditionandalllocal
codesandordinances,if amatingwallreceptacleis not
available,it is thepersonalresponsibilityandobligationof
thecustomertohavea properlygrounded3-prongwall
rece)tacteinstalIedby aqualifiedelectrician.
Powercordmayincludea currentinterrupter
device Atest andresetbuttonisprovidedon the
plugcase.Thedeviceshouldbetestedon a
periodicbasisby firstpressingtheTESTbutton
andthenthe RESETbutton Ifthe TESTbutton
doesnottripor if the RESETbuttonwillnot stay
engaged,discontinueuseofthe airconditionerand
contacta qualifiedservicetechnician.
NOTE: The shape may be different according to its rnodet
Use Wail Receptacle Power Supply
Standard 125V,
3-wire grounding
receptacle rated
15A. t25V AC
Standard 250V,
3-wire grounding
receptacle rated
r5A, 250V AC
Use I5 AMP. time
delay fuse or 15 AMP
circuit breaker
Standard 250V,
3-wire grounding Use 20 AMP. time
receptacFe rated delay fuse or 20 AMP
20A, 250V AC circuit breaker
Electrical Shock Hazard
Plug into a grounded 3 prong outlet
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in
death, fire, or electrical shock.
You can choose between the two methods below according to your preference and window sill shape.
USING SLIT "A"
Fasten the stopper using Type A screw, and lead the
power cord out through slit "A".
Screw
-4-
USING SLIT "B"
Fasten the stopper using left screw hole, and rotate
properly to lead the power cord out through slit "B".
Screw (Type ,_
,)